Selling 10 more units will appear 1 free order, or you could just buy 10 units and get 1 unit free
5 3M N95 masks GIVEAWAY for Q VIPs. Apply >
The item may not ship to your country. Contact seller and request shipping to your location.
Available Shipping Methods:
Please note: Standard and expedited shipping costs are only estimates; the actual cost will be shown on the Order Page.
US$5.02 - US$5.02
100 PCS (MOQ)
US$3.85 - US$3.85
500 PCS (MOQ)
US$0.98 - US$1.08
5 pcs (MOQ)
The smartphone stand is made from aluminum alloy, rubber, 304 stainless steel and nylon plastic. It is applicable to outdoor use. The stand is table and shockproof. The stand is easy to install and use. It is compatible with smartphones sizes of 4.7-7.12 inch. The stand can be universal adjustment at a rotation angle of 360°. It matches various bases.
* The smartphone stand can be adjusted according to one’s mobile phone width freely to be fixed for its use.
* The smartphone stand is widely compatible with mobile phones from 4.7 inch to 7.12 inch on the market.
* The smartphone stand is with universal adjustment design at a rotation angle of 360° to make it convenient for use.
* The smartphone stand has a humanized design to compatible for mobile phones of height between 13.5-18.5cm and width between 5.5-9.2cm.
* The smartphone stand is fixed tightly to be stable and shockproof so as to avoid smartphone dropping.
* The smartphone stand matches various bases freely and has multiple installation ways with different bases.
Product Name: Smartphone stand
Applicable Scene: Bicycle, motorbike
Step 1: Install the grippers at two sides
1. Put the grippers into the grooves on the both sides
2. Put nut on the gripper and aim it at the gripper hole
3. Use fingertip to press the nut at its back and put screw inside the hole; use screwdriver to turn it tightly
Notice: Gripper width is adjustable following smartphone’s width.
Step 2: Anti-skip gripper cover installation
1. Totally two pairs of gripper cover, just put it on the gripper vertically
2. The right and left gripper cover must be distinguished to install
Notice: Upper and lower gripper cover must be distinguished.
Step 3: Bulb Installation
Put nut into the positioning groove of stand body, use finger to press it and aim the bulk hole at the stand hole, then put the screw in and screw it tightly
Notice: Screw it tightly to avoid loose dropping.
Step 4: Anti-skip Gum Installation
Just tear the 3M gum paper to stick it by aiming at the middle groove. The gum is super sticky, wear resistant and stable.
Notice: Pls stick the gum after confirm the edge.
Find answers in product info, Q&As
Please make sure that you are posting in the form of a question.
Your question has been submitted successfully !
Thank you for subscribing!
The discount code has been sent to your mailbox.
Please check it carefully.
Copyright ©2014-2021 Tinkleo.com All Rights Reserved.