Selling 10 more units will appear 1 free order, or you could just buy 10 units and get 1 unit free
5 3M N95 masks GIVEAWAY for Q VIPs. Apply >
$200-$10
$100-20
Available Shipping Methods:
Please note: Standard and expedited shipping costs are only estimates; the actual cost will be shown on the Order Page.
Overview
It has ceramic stainless steel knife head, it can quick break hair and without stuck hair, it charged by usb and it can be charged in a variety of ways, such as desktop computer, notebook computer and mobile power supply, it has IPX7 standard waterproof and the whole machine waterproof, there is cute cartoon pattern on the razor, it adopts resistance design and it is easy to use
Features
* It has ceramic stainless steel knife head, it can quick break hair and without stuck hair, it will not make the children feel pain
* With IPX7 waterproof certification of the hair shaver, all-round to meet the needs of daily life waterproof and the whole machine waterproof
* It charged by usb and it can be charged in a variety of ways, such as desktop computer, notebook computer and mobile power supply
* It adopts resistance design, people can open or close it more easily and easy to control it when use
* It has cartoon pattern on it, it will absorb people’s attention and children will more like it
Product Specification
Product: Baby electric hair shaver
Model: YD-0520T
Power supply waterproof: Charging, plugging
Charging cable: USB charging cable
Voltage: 5.0V
Charging time: 5 hours
Waterproof: IPX7
Maintenance
Usage
Dis assembly tutorial
Three-section method
1. Hold the hair clipper with both hands, and the index finger of the left hand will catch the back of the knife head (to prevent the knife head from falling and then fall)
2. Press the thumb with both hands and press the knife head down. It is a little resistance. Press it hard. The new machine circlip is a little tight.
3. Remove the cutter head and catch it with your hand.
Three-step method
1. Align the bottom of the cutter head with the body card slot
2. After aligning, press the cutter head firmly until the circlip clicks on the cutter head.
3. Loading the cutter head to complete
Three-step method of combing
1. Align the comb sleeve (the required length is facing up) with the slot on the side of the cutter head, and insert it into the side first.
2. Put the other side in again, and after hearing the slamming, the two sides snap into the fuselage groove.
3. Push by hand to confirm that the card is secure, no obvious sliding indicates loading
Please make sure that you are posting in the form of a question.
*Questions:0/2000
Your question has been submitted successfully !
Thank you for subscribing!
The discount code has been sent to your mailbox.
Please check it carefully.
Copyright ©2014-2022 Tinkleo.com All Rights Reserved.